Wednesday, 24 April 2019

LED Binary Counter


In this experiment we get a hands on experience on the DSP board of TI, we understood the basics of flash programming and proper use of JTAG.
In the given experiment, we utilized the on board LEDs to show the binary counting action happening, from 0-15 in binary.
Once the flash programming was done, even after the power was removed and external power source was used, the DSP board still contained and ran the same code, hence we saw that if we want the same code to run on the Board, without interruptions then Flash programming is our go-to choice.
Posted by at

4 comments:

  1. Riya Halder24 April 2019 at 08:01

    can you explain more about JTAG?

    ReplyDelete
    Replies
    1. Darshan24 April 2019 at 22:32

      ​JTAG is a common hardware interface that provides your computer with a way to communicate directly with the chips on a board. ... Today JTAG is used for debugging, programming and testing on virtually ALL embedded devices.

      Delete
  2. Priyank Shah24 April 2019 at 22:14

    Since when did you started blogging!!

    ReplyDelete
  3. Vidhit Varma24 April 2019 at 22:14

    Good Work!

    ReplyDelete

Subscribe to: Post Comments (Atom)